DigiDesign Pro Tools Especificações descarregar pdf (Página 67)

Chapter 10: PRE Support 61

Viewing Mic Preamp Controls

in Pro Tools

Both the Mix and Edit windows can be config-

ured to show or hide PRE controls.

To show or hide Mic Preamp controls in the Mix

and Edit windows:

 Choose View > Mix Window or View > Edit Win-

dow, or click the View Selector in the Edit win-

dow or Mix window, and do one of the

following:

• Select Mic Preamps View to show all Mic Pre-

amp controls, or deselect to hide.

• Select All to display the Pro Tools input/out-

put controls, Mic Preamps, inserts, sends,

and comments.

• Select None to hide Pro Tools input/output

controls, Mic Preamps, inserts, sends, and

comments.

Mic Preamp Controls

The Mic Preamps view provides all the essential

controls for a PRE channel in the Mix and Edit

windows.

Source and Input Impedance Selector

Clicking the up/down arrows in the Mic Preamp

window accesses two sets of controls. The top

half of this pop-up menu sets the input source

for the PRE channel to Mic, Line, or DI (instru-

ment). The bottom half of this pop-up menu

sets the input impedance for a PRE channel to

1.5 kΩ, 15 kΩ, or 1.5 MΩ.

Mic Preamp Window Button

Clicking the Mic Preamp Window button

(labeled mic, inst, or DI) opens a floating Mic

Preamp window, an alternative to Mix and Edit

window views. See “Mic Preamp Window” on

page 62.

Phase Button

This button applies phase reversal to individual

channels.

High-Pass Filter Button

This button applies a high-pass filter to individ-

ual channels.

Each PRE channel includes a high-pass filter

with a center frequency of 85 Hz and a roll-off of

–18 dB/octave. Use the high-pass filter to re-

move microphone proximity effects, hum, rum-

ble, wind, and other low frequency sounds.

Mic Preamps View, Mix window

Source and

Impedance

HPF

Insert

Mic Pre window

Pad

Phantom

Power

Phase

Gain

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 73

Comentários a estes Manuais

Sem comentários

DigiDesign Pro Tools Especificações Página 67

Comentários a estes Manuais