DigiDesign MachineControl Guia do Utilizador descarregar pdf (Página 30)

MachineControl Guide26

Using Remote Track Arming

The first step in using Remote Track Arming is to

configure the parameters of the Track Arming

window.

To conﬁgure Track Arming:

1 Make sure your machine is properly con-

nected and conﬁgured to slave to Pro Tools as

described in your MachineControl and

Pro Tools Guides.

2 Make sure Transport = Machine.

3 Open the Track Arming window. If the entire

window is not visible, click the zoom box.

4 Designate the number of record tracks using

the Record Tracks popup. If you are using the ge-

neric device personality, set the number of

record tracks to 8.

5 Select a Record Protocol (Auto Edit or Punch

In/Out).

6 Select a Record Mode (Insert or Assemble).

To perform a layback:

1 In Pro Tools, select the audio to layback, or

place the playback cursor at a start point.

2 In the Remote Track Arming window, arm the

appropriate tracks.

3 Select Transport > Machine in the Pro Tools

Transport window.

4 Click Record in the Transport window to arm

recording.

5 Click Play in the Transport Window.

Your machine will cue to the selection start mi-

nus all relevant pre-roll, then begin to play back.

Pro Tools will then sync to the deck, and the tar-

get deck will record as determined by your set-

tings for Record Protocol and Record Mode. If

you did not create an on-screen selection, deck

recording will continue until you manually stop

playback.

Once the Track Arming parameters are con-

figured, you can change the Track Arming

window to “small view” and still see the

track arm buttons.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 45 46

Sem comentários

DigiDesign MachineControl Guia do Utilizador Página 30